Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving Clovis, NM

Richards-Wilcox Commercial Garage Door Repair in Clovis, NM

Repairs for commercial sectional, overhead and service doors. Typical cost $250-$1,000.

Our Richards-Wilcox commercial garage door repair service in Clovis, NM comes down to three things: a clear diagnosis, the right parts on the truck, and a door that is balanced and safety-tested when we finish. Repairs for commercial sectional, overhead and service doors. We work on Richards-Wilcox commercial doors of every age, from older models to current lines, and carry or can source compatible parts.

Safety first: springs and cables hold hundreds of pounds of tension. Don't try to adjust or remove them yourself, and don't run the opener on a door that's crooked or has a broken spring.

Is it time for Richards-Wilcox commercial garage door repair?

  • The door won't open or close, holding up deliveries
  • Damage from forklifts or trucks
  • Broken springs or cables on a heavy commercial door
  • The operator faults or stops

Common causes

  • High cycle counts
  • Vehicle impact
  • Worn springs, cables and rollers

Before the technician arrives

  • Put the door out of service and keep staff clear.
  • Note any fault codes on the operator.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

How we handle Richards-Wilcox commercial garage door repair

  1. Secure the door and assess the damage
  2. Quote parts and labor
  3. Repair springs, cables, sections or track
  4. Adjust or repair the operator
  5. Test safety devices

How much does Richards-Wilcox commercial garage door repair cost?

$250-$1,000Typical range, parts & labor
1-4 hoursTypical time on site

What moves the price:

  • Door size, gauge and cycle rating
  • Operator type and controls
  • Parts availability for your model
  • Lift equipment and after-hours access

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Other Richards-Wilcox services

Serving Clovis, NM and nearby towns

Fine dust in New Mexico packs into roller bearings and the track, so rollers start to drag and squeal well before they are worn out.

Our Richards-Wilcox commercial garage door repair service covers Clovis (ZIP codes 88101 and 88102) and nearby towns including Portales (16.8 mi), Muleshoe, TX (30.1 mi), Friona, TX (31.9 mi) and Dimmitt, TX (51.9 mi). Call (833) 435-8883 to book a visit in Clovis.

Richards-Wilcox Commercial Garage Door Repair: frequently asked questions

How much does Richards-Wilcox commercial garage door repair cost in Clovis, NM?

Richards-Wilcox Commercial Garage Door Repair typically costs $250-$1,000 including parts and labor, and usually takes 1-4 hours. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do Richards-Wilcox commercial garage door repair the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is Richards-Wilcox commercial garage door repair covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty, and Richards-Wilcox warranty terms vary by product and age. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where New Mexico or Clovis requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my commercial door?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the commercial door is near the end of its life, replace it. Commercial doors are rated by cycles. If the door has reached its rated cycle life, has several damaged sections, or parts are no longer made, replacing it is often cheaper over the next few years. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in Clovis, NM

Midland Garage Door Garage Door Repair

Diagnosis and repair for doors that are stuck, noisy, crooked or won't open or close.

Typical $150-$450

Overhead Door Rolling Fire Door Inspection & Drop Testing

Annual drop testing and inspection of rolling fire doors.

Typical $150-$500

Raynor Opener Circuit Board Replacement

Failed logic boards and receivers replaced, often after a power surge.

Typical $175-$400

Genie Opener Gear & Sprocket Replacement

Genie is the residential opener brand of the Overhead Door Corporation. Genie openers use Intellicode rolling-code remotes, Genie is one of the few brands still offering screw-drive openers, and newer models connect to the Aladdin Connect app.

Typical $125-$275

LiftMaster Opener Gear & Sprocket Replacement

LiftMaster is the professional-installer brand of The Chamberlain Group. The color of the learn button on the motor unit shows which remotes are compatible (yellow on Security+ 2.0 models; purple, red, orange or green on older ones), and most current models work with the myQ app.

Typical $125-$275

Clopay Torsion Spring Replacement

Clopay is one of the largest residential garage door makers in North America, with lines such as Classic, Modern Steel, Coachman and Canyon Ridge. The model is usually printed on a label on the door's end stile, which helps us match replacement panels.

Typical $200-$450

Garage Door Sensor Repair

Photo-eye sensors realigned, rewired or replaced so the door closes reliably.

Typical $100-$250

Overhead Door Weather Seal Replacement

Overhead Door traces its roots to C.G. Johnson, who invented the upward-acting garage door in 1921. The company builds residential and commercial doors and openers.

Typical $100-$300

Linear Opener Gear & Sprocket Replacement

Linear openers and remotes are now part of Nice North America. Linear's MegaCode remotes are common on older openers and gate systems.

Typical $125-$275

Hörmann Extension Spring Replacement

Hörmann is a German manufacturer of residential and commercial doors and openers with North American operations.

Typical $150-$350

Steel Garage Door Repair

Dents, rust and bent sections on steel doors repaired or replaced.

Typical $150-$600

Holmes Garage Door Off-Track Garage Door Repair

Doors that have come off their tracks secured, re-hung and realigned.

Typical $175-$450

Garage door stuck, noisy or broken?

Talk to a garage door technician in Clovis, NM now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote